Dakota 2WD V8-4.7L VIN J (2005)
Transmission Speed Sensor: Service and Repair
Automatic Transmission 42RLE
Sensor-Input Speed
SENSOR-INPUT SPEED
REMOVAL
1. Raise vehicle.
2. Place a suitable fluid catch pan under the transmission.
3. Remove the wiring connector from the input speed sensor.
NOTE: The speed sensor bolt has a sealing patch applied from the factory. Be sure to reuse the same bolt.
4. Remove the bolt holding the input speed sensor to the transmission case.
5. Remove the input speed sensor from the transmission case.
INSTALLATION
1. Install the input speed sensor (1) into the transmission case.
NOTE: Before installing the speed sensor bolt, it will be necessary to replenish the sealing patch on the bolt using Mopar(R) Lock & Seal Adhesive.
2. Install the bolt to hold the input speed sensor into the transmission case. Tighten the bolt to 9 Nm (80 inch lbs.).
3. Install the wiring connector onto the input speed sensor
4. Verify the transmission fluid level. Add fluid as necessary.
5. Lower vehicle.
Sensor-Output Speed
SENSOR-OUTPUT SPEED
REMOVAL
1. Raise vehicle.
2. Place a suitable fluid catch pan under the transmission.
