Dakota 2WD V8-4.7L VIN J (2005)
3. Make sure oil pan (1) and case rail are clean and dry. Install an 1/8 bead of RTV to the transmission oil pan and install to case. Tighten bolts (2) to
20 Nm (14.5 ft. lbs.).
4. Lower vehicle and connect the TRS connector.
5. Connect solenoid/pressure switch assembly connector.
6. Lower vehicle.
7. Fill transmission with ATF+4, Automatic Transmission Fluid. Verify proper fluid level.
NOTE: If the valve body has been reconditioned or replaced, it is necessary to perform the Quick Learn Procedure.
