Dakota 2WD V8-5.9L VIN Z LDC (2000)
If equipped with A/C, the generator and A/C compressor along with their common mounting bracket must be partially removed. Removing generator
or A/C compressor from their mounting bracket is not necessary. A1SO7 discharging A/C system is not necessary. Do not remove any refrigerant lines
from A/C compressor.
WARNING: THE A/C SYSTEM IS UNDER PRESSURE EVEN WITH ENGINE OFF. REFER TO REFRIGERANT WARNINGS IN
HEATING AND AIR CONDITIONING.
1. Disconnect battery negative cable.
2. Partially drain cooling system.
Do not waste reusable coolant. If solution is clean, drain coolant into a clean container for reuse.
3. Remove upper radiator hose clamp and hose at radiator.
4. Unplug wiring harness from A/C compressor.
5. Remove air cleaner assembly.
6. Remove accessory drive belt as follows: The drive belt is equipped with a spring loaded automatic tensioner. Relax tension from belt by rotating
tensioner clockwise (as viewed from front). When all belt tension has been relaxed, remove accessory drive belt.
7. The drive belt idler pulley must be removed to gain access to one of A/C compressor/generator bracket mounting bolts. Remove idler pulley bolt
and remove idler pulley.
8. Remove oil dipstick tube mounting bolt at side of A/C-generator mounting bracket.
