Dakota 4WD V6-239 3.9L Magnum (1996)
Fig. 10 Intake Manifold Locator Dowels
4. Install four plastic locator dowels into block holes, Fig.10.
5. Apply silicone rubber adhesive sealant slightly higher than crossover gasket (approximately 0.2 inch) to four corner joints. Excessive sealant may
reduce flange gasket effectiveness.
6. Install front and rear crossover gaskets onto dowels, then install flange gasket. Ensure vertical port alignment tab is resting on block deck face and
horizontal tabs align with mating cylinder head gasket tabs.
7. Lower manifold into position and ensure seal placement, then remove alignment studs.
Fig.11 Intake Manifold Tightening Sequence
