Dakota 4WD V6-239 3.9L VIN X FI (1989)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Hydraulic Valve Mounting and Connections
REMOVAL
1. Disconnect battery ground cable.
2. Raise and support vehicle.
3. Disconnect valve and sensor harness connectors.
4. Disconnect brake lines at valve.
5. Remove valve attaching nuts and remove valve.
6. Disconnect valve wiring and remove valve.
INSTALLATION
1. Connect wiring to valve.
2. Position valve on frame.
3. Install and tighten valve attaching nuts.
Torque to 16-25 ft lb (22-34 Nm).
4. Connect brake lines to valve.
5. Connect valve-to-sensor harness wires.
6. Bleed the hydraulic valve and brakes.
7. Lower vehicle.
8. Reinstall battery ground cable.
