Dakota 4WD V6-239 3.9L VIN X FI (1989)
Parking Brake Cable: Service and Repair
Front Cable Replacement
Fig 1 Parking Brake Pedal Assembly
REMOVAL
1. Raise vehicle.
2. Loosen cable adjusting nut and disengage front cable from intermediate cable connector.
3. Remove clip attaching front cable to frame rail with pry tool. Then press cable out of frame rail. Remove guide clip from frame rail on 4-wheel
drive models.
4. lower vehicle.
5. Fold left front edge of floor covering rearward and remove cable boot from floor pan.
6. Engage parking brake pedal and work front cable up and out of clevis linkage in pedal assembly.
7. Pry upper end of cable housing and clip downward and out of pedal assembly bracket.
8. Work cable and housing assembly up through floor pan.
9. Remove front cable from vehicle.
Fig 2 Parking Brake Cables