Dakota 4WD V6-3.7L (2008)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Hydraulic Control unit (HCU) - Installation
INSTALLATION
NOTE: If the ABM is being replaced with a new ABM it must be reprogrammed with the use of a scantool.
1. Reinstall the HCU assembly (5) to the vehicle.
2. Install HCU assembly (5) on the battery tray (2) and Tighten the nuts to 15 Nm (11 ft. lbs.).
3. Install the brake lines (3) to the HCU (1) and tighten to 19 Nm (170 in. lbs.).
4. Install the electrical harness connector (4) to the ABM (3).
