Dakota 4WD V6-3.7L (2008)
2. Disconnect the HVAC wire harness (2) from the mode door actuators (3 and 4) located on the driver side end of the HVAC housing.
3. Remove the screws (5) that secure the mode door actuators to the HVAC housing and remove the actuators.
4. Disconnect the HVAC wire harness (1) from the evaporator temperature sensor (2) and the blend door actuator (3) located on the top of the HVAC
housing (4).
5. Remove the screws (5) that secure the blend door actuator to the HVAC housing and remove the actuator.
6. Remove the evaporator temperature sensor from the HVAC housing.
7. Remove the lever and linkage rod (1) from the blend door pivot shaft (2) located on the top of the HVAC housing (3).
8. Carefully disconnect the lever and linkage rod from the blend door pivot lever (4).
9. Disconnect the HVAC wire harness (1) from the blower motor resistor (2), recirculation door actuator (3), and the blower motor (4).
10. Remove the three screws (5) that secure the blower motor to the HVAC housing (6) and remove the blower motor.
11. Remove the HVAC wiring harness from the HVAC housing.
