Dakota 4WD V6-3.7L (2008)
24. To remove the blend-air door (1) from the inside of the HVAC housing (2), first carefully release the retaining tab of the blend door pivot lever (3)
from the pivot shaft of the blend door, using a small pick-type tool.
25. Pull the blend door pivot lever out of the pivot shaft of the blend-air door.
26. Remove the air vane (1) from the upper half of the HVAC housing (2).
NOTE: If the rubber evaporator core seal is deformed or damaged, the seal must be replaced.
27. Remove the rubber evaporator core seal (3) from the HVAC housing.
NOTE: If the seal on any air door is deformed or damaged, the air door must be replaced.
28. Remove both blend-air doors (4) and the defrost/floor-air door (5) from the HVAC housing.
Air Inlet Housing
AIR INLET HOUSING
NOTE: The air inlet housing must be removed from HVAC housing and disassembled for service of the recirculation-air door.
