Dakota 4WD V6-3.7L (2008)
NOTE: If this flash process is interrupted or aborted, the flash should be restarted.
11. Continue to SECTION 2 - ADDITIONAL PCM / TCM REPLACEMENT PROCEDURES to complete the process if the ECU has been
replaced.
12. Type the necessary information on the "Authorized Modification Label" (p/n 04275086AB) and attach near the VECI label (See
SECTION 3 - AUTHORIZED MODIFCATION LABEL for details).
SECTION 2 - ADDITIONAL PCM / TCM REPLACEMENT PROCEDURES
Find the PCM/TCM Type for the vehicle (below), read and write down the steps, and then go to the step by step instructions (immediately
following) for additional information on how to perform these procedures.
If a NGC3 or NGC4 PCM was replaced, perform the following additional steps and/or routines:
1. PCM Replaced - if WCM equipped
2. Learn ETC - if ETC equipped
3. Check PCM Odometer
4. Check PCM VIN - if NOT WCM equipped
5. Quicklearn - if EATX equipped
If a GPEC PCM was replaced, perform the following additional steps and/or routines:
1. If the vehicle is equipped with a CVT, ensure that the TCM has the latest software calibration available (if the vehicle is not equipped with
a CVT, skip to Step 3).
2. PCM Replaced - if WCM equipped
3. Learn ETC
4. Check PCM Odometer
5. Check PCM VIN - if NOT WCM equipped
6. TCM Quicklearn - if EATX equipped
If a CVT TCM was replaced, perform the following additional steps and/or routines:
1. Initialize CVT
If an EGS TCM was replaced, perform the following additional steps and/or routines:
1. Initialize EGS
STEP-BY-STEP INSTRUCTIONS
Check PCM Odometer
From the "Home" screen, select "ECU View".
- Select "PCM"
- Select "Misc. Functions"
- Select "Check PCM Odometer" and follow the on screen instructions.
- When complete, select "Finish".
Check PCM VIN
From the "Home" screen, select "ECU View"
- Select "PCM"
- Select "Misc. Functions"
- Select "Check PCM VIN" and follow the on screen instructions.
- When complete, select "Finish"
Initialize CVT
From the "Home" screen, select "ECU View"
- Select "TCM"
- Select "Misc. Functions"
- Select "Initialize CVT" and follow the on screen instructions.
- When complete, select "Finish"
Initialize EGS
From the "Home" screen, select "ECU View"
- Select "TCM"
- Select "Misc. Functions"
- Select "Initialize EGS" and follow the on screen instructions.
- When complete, select "Finish"
Learn ETC
From the "Home" screen, select "ECU View"
- Select "PCM"