Dakota 4WD V6-3.7L (2008)
3. Install the lower part of the shock module (2) into the lower control arm shock bushing.
4. Position shock module (2) to lower control (6). Install bolt (4) so head of bolt is facing rear of vehicle and hand start nut (3). Tighten the bolt (4)
& nut (3) to 210 Nm (155 ft. lbs.).
5. Install the stabilizer link lower nut (5) to the lower control arm (6). Tighten the nut to 102 Nm (75 ft. lbs.).See: Stabilizer Bar/Stabilizer
Link/Service and Repair/Front Stabilizer Link - Installation.
6. Insert ball joint (6) in steering knuckle (7) and tighten ball joint nut to 95 Nm (70 ft. lbs.).
7. Reposition the wheel speed wire (5) into the retaining brackets (3).
8. Install the caliper slide pin bolts (2). Tighten to 32 Nm (24 ft. lbs.)
9. Remove the support from the lower control arm outboard end.
10. Install the tire and wheel assembly See: Wheels and Tires/Service and Repair/Removal and Replacement.
11. Remove the support and lower the vehicle.
