Dakota 4WD V6-3.7L (2008)
Overdrive Solenoid: Service and Repair
Installation
INSTALLATION
NOTE: If the Solenoid/Pressure Switch assembly is being replaced, the Quick Learn Procedure must be performed. See: Control Module/Service
and Repair/TCM Quick Learn
1. Install Solenoid/Pressure Switch Assembly (1) and screen (3) to the separator and transfer plates.
2. Install and tighten retaining screws (2) to 5.5 Nm (50 in. lbs.) torque.
3. Install valve body. See: Valve Body/Service and Repair/Removal and Replacement/Installation