Dakota 4WD V6-3.7L (2008)
Clutch Release Fork: Service and Repair
Installation
INSTALLATION
NOTE: The hydraulic linkage is serviced as a complete assembly only. The individual components must not be serviced separately.
1. Ensure clutch reservoir (1) cap is tight
2. Install clutch reservoir (1) in dash panel and tighten nuts to 5 Nm (40 in. lbs.).
3. Install clutch cylinder (2) in dash panel and tighten nuts to 54 Nm (40 ft. lbs.).
4. Connect clutch pedal position switch connector (3) to wiring harness.
5. Install hydraulic fluid line (4) clip into the hole in the lower dash panel.
6. Apply light coating of grease to the inner diameter of the clutch cylinder push rod (1) and outer diameter of the clutch pedal pin (2).
7. Install clutch cylinder push rod (1) on clutch pedal pin (2) and install retaining clip.
