Dakota 4WD V6-3.7L (2008)
Seals and Gaskets: Service and Repair
NV244 Transfer Case
Removal
REMOVAL
1. Raise vehicle.
2. Remove the front propeller shaft See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Removal and
Replacement/Rear.
3. Remove the front propeller shaft seal boot (1) retaining clamp (2).
4. Remove the front propeller shaft seal boot (2) from the front output shaft seal slinger (3).
5. Using a suitable hammer and chisel, strike the seal slinger (2) with the chisel as shown in three, equally spaced locations.
NOTE: The indentations (2) should appear as shown here.