Dakota 4WD V6-3.9L VIN X (1997)
4.
Disconnect the rear chassis brake tube from the rear brake hose and cap the brake tube (Figure 5).
NOTE:
DO NOT allow brake fluid to drip or spill on painted surfaces as this may damage the paint. If brake fluid contacts a painted surface, flush with water
immediately.
5.
Remove the retaining clip and disconnect the rear brake hose from the mounting bracket.
6.
Disconnect the left and right rear brake tubes from the rear brake hose (Figure 6).
7.
Remove the brake hose bracket nut from the RWAL/ABS speed sensor bracket (Figure 6).
8.
Remove the rear brake hose from the clips and discard the brake hose.
9.
Install the new brake hose into the clips.
10.
Install the brake hose bracket onto the RWAL/ABS speed sensor bracket (Figure 6). Tighten the bracket nut to 195 in-lbs (24 Nm).
