Dakota 4WD V6-3.9L VIN X (1997)
Cruise Control Servo: Service and Repair
REMOVAL
1. Disconnect negative battery cable at battery.
2. Disconnect vacuum hose at servo.
3. Unplug electrical connector at servo.
4. Remove 2 servo mounting nuts holding cable sleeve to mounting bracket.
5. Block throttle to full open position.
Speed Control Cable
6. Pull speed control cable sleeve away from servo to expose cable hairpin (retaining) clip.
7. Remove clip attaching cable to servo.
8. Remove servo from mounting bracket.
INSTALLATION
1. Position servo to mounting bracket.
2. Block throttle to full open position to align hole in cable connector with hole in servo pin. Install cable-to-servo retaining clip.
3. Install servo mounting nuts and tighten to 8.5 N.m (75 in. lbs.).
4. Connect vacuum hose at servo.
5. Connect electrical connector at servo.
6. Remove throttle block.
7. Connect negative battery cable to battery.
