Dakota 4WD V6-3.9L VIN X (1997)
High Pressure Sensor / Switch: Service and Repair
Fig 25 High Pressure Cut-off Switch -- Typical
HIGH PRESSURE CUT-OFF SWITCH
Removal
1. Disconnect and isolate the battery negative cable.
2. Unplug the wire harness connector from the switch.
3. Unscrew the switch from the discharge line fitting.
Installation
1. Install and tighten the switch.
2. Unplug the wire harness connector into the switch.
3. Connect the battery negative cable.
Fig 29 Low Pressure Cycling Clutch Switch Removal/Installation
LOW PRESSURE CYCLING CLUTCH SWITCH
1. Disconnect and isolate the battery negative cable.
2. Unplug the wire harness connector from the low pressure cycling clutch switch near the top of the accumulator.
3. Unscrew the switch from the fitting on the accumulator.
4. Reverse the removal procedures to install.
