Dakota 4WD V6-3.9L VIN X (1997)
12.
Connect the wiring connector to the ACM. Make sure it is fully seated and the lock bars are engaged.
13.
Install the ground eyelet screw to the left side of the ACM bracket.
14.
Install the center instrument panel support bracket.
15.
Install the two (2) left side and one (1) right side support bracket screws (Figure 6). Tighten the bracket screws to 105 in-lbs (11.8 N.m).
16.
Install the two (2) front center support bracket screws (Figure 6). Tighten the bracket screws to 105 in-lbs (11.8 N.m).
17.
Reinstall the floor carpet around the center instrument panel support.
18.
Connect the DRB III, turn the ignition switch to the ON position and then exit the vehicle with the DRB III.
19.
Reconnect the negative battery cable and then watch the airbag light in the instrument cluster, it should light for about 6-8 seconds and then go out.
20.
With the DRB III, verify that no system diagnostic codes have been set.
NOTE:
If the airbag warning lamp fails to light or the light stays on, or the DRB displays a diagnostic code, a system malfunction exists. Diagnose and repair
the condition following normal service procedures.
Service Procedure For Wrangler (TJ) Vehicles:
1.
With the ignition key in the OFF position, disconnect and isolate the negative battery cable. WAIT TWO (2) MINUTES FOR THE SYSTEM
CAPACITOR TO DISCHARGE BEFORE CONTINUING.
Note:
To enhance customer satisfaction, remember to record all radio settings before disconnecting the battery and to reset all electronic memory (clock,
radio settings, etc.) when you have completed the service procedure.
2.
Pull back the floor carpet from the area under the heater-A/C housing floor duct and forward of the center floor console.
3.
For vehicles equipped with ABS: Remove the ABS acceleration sensor from its mounting bracket and set aside (Figure 9).