Dakota 4WD V6-3.9L VIN X (1997)
7. Hold accumulator housing firmly in place and install remaining two attaching screws. Be sure springs and clutch valve plug are properly seated.
Tighten screws to 4 Nm (35 inch lbs.).
3-4 Accumulator Reassembly
Accumulator Housing Components
1. Lubricate accumulator piston, seals and housing piston bore with clean transmission fluid.
2. Install new seal rings on accumulator piston.
3. Install piston and spring in housing.
4. Install end plate on housing.
3-4 Accumulator 1
