Dakota 4WD V8-318 5.2L (1991)
POWER BRAKE BOOSTER INSTALLATION
1. Position gasket on booster studs.
2. Guide booster studs into dash panel holes and seat booster on panel.
3. Install and tighten booster attaching nuts to 28 Nm (250 in. lbs).
4. Install booster push rod on brake pedal. Secure rod to pedal with retaining clip.
5. Install booster check valve if removed and connect vacuum hose to check valve.
6. Position master cylinder on brake booster mounting studs.
7. Slide combination valve bracket onto cylinder mounting studs.
8. Install and tighten cylinder mounting nuts to 28 Nm (250 in. lbs).
9. Connect brake lines to master cylinder. Tighten line fittings to 19 Nm (170 in. lbs).
10. Connect ground wire to combination valve bracket.
11. Tighten any brake lines at combination valve and rear antilock valve, if loosened or disconnected.
12. Fill and bleed brake system.
