Dakota 4WD V8-318 5.2L (1991)
Disconnecting Quick Connect Fittings (Screwdriver)
1.
Bend the retainer tabs down.
2.
Insert a screwdriver between the retainer clips pull tab and the body of the Quick-Connect fitting.
3.
Rotate the screwdriver 90 degrees to lift the retainer clip.
4.
Raise the pull tab while pushing the legs of the retainer clip away from each other.
5.
Raise the retainer clip until the hooks on the legs of the retainer clip clears the fuel tube.
6.
Pull fuel tube out of the Quick-Connect fitting.
7.
Check the connector body and retainer for damage. Replace if necessary.
INSTALLATION
Quick Connect Fitting Assembly/Disassembly (Screwdriver)
1.
Before installing the fuel tube into Quick-Connect fitting, clean the fuel tube and lubricate the nipple with new engine oil.
2.
Push fuel tube into Quick-Connect fitting until the stop on the fuel tube rests against the back of the Quick-Connect fitting.
3.
Push the retainer clip into the slot in the Quick-Connect fitting until it locks in place.
4.
Bend the retainer clip tabs up into their locking position.
