Dakota 4WD V8-318 5.2L (1991)
Crankshaft Position Sensor: Service and Repair
Hall Effect Pick-Up Removal And Installation
REMOVAL
1.
Disconnect Hall effect pick-up leads at wire harness connector. Remove distributor cap and rotor.
2.
Remove both Hall effect pick-up attaching screws on opposite sides of the distributor housing and carefully lift the Hall effect pick-up assembly
from the distributor housing.
INSTALLATION
1.
Place the Hall effect pick-up assembly into the distributor housing and align with housing.
2.
Attach both mounting screws and tighten.
3.
Install distributor rotor and cap. Connect Hall effect pick-up leads at wire harness connector.
4.
Set timing, refer to ADJUSTMENTS PROCEDURES.