Dakota 4WD V8-318 5.2L (1991)
2.
Mount ignition switch to column. If equipped with column shift, the shifter must be in the Park position and the park dowel pin on ignition switch
must engage with column park lock slider linkage.
3.
To verify ignition switch is in lock position, the flag should be parallel with the ignition switch terminals.
4.
Apply a small amount of grease to flag and pin, then position park lock link and slider to mid-travel.
5.
Position ignition switch against lock housing face. Ensure that pin is inserted into park lock link contour slot. Torque retaining screws to 17 inch
lbs.
6.
Install cover to column, then tilt lever.
7.
Connect battery ground cable.
8.
With the key cylinder and ignition in the lock position, insert key cylinder until it bottoms out.
9.
Insert key, then push the key cylinder inward and rotate key cylinder clockwise to end of travel.
10.
Ensure proper operation of switch and lock assembly.
