Dakota 4WD V8-318 5.2L (1991)
Vehicle Speed Sensor: Description and Operation
Transmission Electrical Connections (3 Speed, W/O Lock-up)
Transmission Electrical Connections (3 Speed, With Lock-up)
Transmission Electrical Connections (4 Speed Overdrive)
This sensor is located in the extension housing of the transmission (2 WD), or the extension housing of the transfer case (4 WD), and it generates 8
voltage pulses for every revolution of the output shaft. These pulses are sent directly to the Single Board Engine Controller (SBEC). These signals are
used to determine distance traveled and vehicle speed. The SBEC also uses these signals, along with the signals from the Throttle Position Sensor (TPS),
to determine the difference between a closed throttle deceleration condition and a closed throttle idle (vehicle stopped) condition.
Under idle (vehicle stopped) conditions, the SBEC receives a signal from the idle contact switch and it also sees that there are no signals being generated
from the vehicle distance (speed) sensor. The engine controller adjusts the Idle Speed Control (ISC) actuator to maintain a desired engine idle speed.
Under closed throttle deceleration, the SBEC receives signals from the idle contact switch and the vehicle distance (speed) sensor, because the vehicle is
still moving, and it adjusts the ISC actuator to maintain a desired MAP value.
