Dakota 4WD V8-318 5.2L (1991)
Power Steering Pump: All Technical Service Bulletins
Drive Belt - Squealing/Chirping Noise
NO.:
07-06-91
GROUP:
Cooling
DATE:
Dec 16, 1991
SUBJECT:
Drive Belt Noise
MODELS:
1991 (AN) Dakota/Dakota Cab & Chassis (Equipped with a 5.2L Engine)
SYMPTOM/CONDITION:
A squealing and/or chirping noise coming from the drive belt when the engine is running. Vehicles experiencing this condition should have the following
procedure performed.
PARTS REQUIRED:
1
Belt, Serpentine Drive (With A/C)
B4061145
1
Belt, Serpentine Drive (Without A/C)
B4061030
REPAIR PROCEDURE:
This procedure involves checking the power steering pump pulley alignment and replacement of the drive belt.
1. Verify that the power steering pump pulley is flush (+ or - 0.010 inch/.254 mm) with the power steering pump shaft.
2. To move the power steering pump pulley to a flush position, use special tool puller C-4333 or installer C-4063 as described on page 19-11 of the
1991 Dakota Service Manual, publication # 81-370-1110.
3. Vehicles that exhibit belt squealing and/or chirping, and the power steering pump pulley is aligned, should have the drive belt replaced as described
on page 7-34 of the 1991 Dakota Service Manual, publication # 81-370-1110.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE Labor Operation No.
Align Power Steering Pump Pulley 07-20-14-90 . . . . . . . . . . . . . . . . . . . . . 0.8 Hrs.
Serpentine Belt Replace 07-20-14-91 . . . . . . . . . . . . . . . . . . . . . 0.2 Hrs.
FAILURE CODE: 68 - Noisy
