Dakota 4WD V8-4.7L (2009)
NOTE: Cab back trim panel with jumper seats shown. Trim panel without similar.
11. Remove the cab back trim panel, See: Trim Panel/Service and Repair/Cab Back Trim Panel - Removal.
12. Remove the jack storage compartment cover.
NOTE: Carpet for Quad Cab models shown. Club Cab similar.
13. Remove the carpet (1) from the vehicle.
Club Cab, With Rear Jumper Seats
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper
precautions could result in accidental airbag deployment.
WARNING: To avoid personal injury or death, during and following any seat belt or child restraint anchor service, carefully inspect all seat
belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace
any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a
damaged or inoperative buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any
child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat
belt or child restraint component. Always replace damaged or faulty seat belt and child restraint components with the correct,
new and unused replacement parts listed in the Chrysler Mopar(R) Parts Catalog.
1. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.