Dakota 4WD V8-4.7L (2009)
6. Disconnect the wire harness connector (5) located at the right A-pillar.
7. If equipped, disconnect the headliner wire harness connector (2) from the inside rear view mirror.
8. If equipped, remove the overhead console, See: Console/Service and Repair/Overhead Console - Removal.
9. Remove the sun visors (4), See: Sun Visor/Service and Repair/Visor - Removal.
10. Remove the sun visor supports (3), See: Sun Visor/Service and Repair/Visor - Removal.
11. If equipped, remove the front dome lamp, See: Lighting and Horns/Dome Lamp/Dome Lamp Bulb/Service and Repair/Dome Lamp - Removal.
12. If equipped, remove the rear dome lamp, See: Lighting and Horns/Dome Lamp/Dome Lamp Bulb/Service and Repair/Dome Lamp - Removal.
13. Remove the two coat hooks, See: Trim Panel/Service and Repair/Coat Hook - Removal.
14. Remove the front seat headrests.
15. Remove the cab back trim panel, See: Trim Panel/Service and Repair/Cab Back Trim Panel - Removal.
16. Remove the rear jumper seat headrests.
17. Remove the rear jumper seat headrest sleeves from the headliner.
18. Lower the rear of the headliner (7) and disconnect the headliner wire harness connector (1) from the center high mounted stop lamp.
19. Recline the front seats.
CAUTION: Be careful not to crease the headliner.
20. Lower the front of the headliner and remove the headliner through the door opening where the seat belt turning loop and height adjuster was
disconnected from the upper roof rail.
Quad Cab
1. Pull the top of each door seal downward slightly.
2. Remove the upper C-pillar trim panels, See: Trim Panel/Service and Repair/Pillar Trim/C-Pillar Trim Panel-Removal.
