Dakota 4WD V8-4.7L (2009)
4. Install the front rotor and brake caliper assembly See: Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and Replacement/Brake
Rotor - Installation.
Rear
INSTALLATION
1. Connect harness to sensor (1). Be sure seal is securely in place between sensor and wiring connector.
2. Install O-ring on sensor (if removed).
3. Insert sensor (1) in differential housing (3).
4. Install the sensor mounting stud and tighten to 24 Nm (200 in. lbs.).
5. Reconnect the electrical connector (6).
6. Install the brake line (3) on the sensor stud.
7. Install the park brake cable (2) and bracket (1) to the stud and install the nut (4).
8. Lower vehicle.