Dakota 4WD V8-4.7L (2009)
Glove Box Lamp: Service and Repair
Glove Box Lamp/Switch - Installation
LAMP/SWITCH
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper
precautions could result in accidental airbag deployment.
1. Position the glove box lamp and switch (3) to the mounting hole in the instrument panel (2).
2. Reconnect the wire harness connector (1) to the lamp and switch.
3. Feed the wire harness back through the switch mounting hole.
4. Align the lamp and switch with the mounting hole in the instrument panel.
5. Using hand pressure, push the lamp and switch firmly and evenly into the mounting hole until it is fully seated.
6. Reinstall the glove box (4) into the instrument panel. See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and
Repair/Instrument Panel Glove Box - Installation.
7. Reconnect the battery negative cable.
