Dakota 4WD V8-4.7L (2009)
Body Control Module: Service and Repair
Front Control Module - Removal
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Remove the Integrated Power Module (IPM) from the engine compartment, See: Relays and Modules - Power and Ground Distribution/Power
Distribution Module/Service and Repair/Integrated Power Module (IPM) - Removal.
3. Remove the four fasteners (2) securing the Front Control Module (FCM) (1) to the Integrated Power Module (IPM) (3).
4. Separate the FCM from the PDC by pulling the two straight away from each other to disengage the electrical connector.