Dakota 4WD V8-4.7L (2009)
possible serious or fatal injury.
NOTE: The unique, keyed center seat belt lower anchor buckle and the right outboard occupant buckle are serviced as a unit with their
anchor brackets. These buckles are secured to the rear floor along with the right side of the rear center seat belt retractor mounting
bracket by a common screw, but can be removed from the mounting bracket and serviced separately from the seat belt and retractor.
See: Seat Belt Retractor/Service and Repair/Seat Belt Retractor - Installation .
1. Position the rear center anchor and right outboard buckle and anchor plate unit (5) to the right side of the rear center seat belt retractor mounting
bracket (4) under the right rear seat cushion (1) on the rear floor panel near the cab back panel.
2. Install and tighten the screw (3) that secures the rear center anchor/right outboard buckle and anchor plate unit and the retractor mounting bracket
to the rear floor panel. Tighten the screw to 39 Nm (29 ft. lbs.).
3. Engage the head of the right outboard seat belt buckle through the elastic strap on the rear edge of the right rear seat cushion.
4. Reach between the rear seat cushion and the rear seat back to engage the rear center seat belt lower anchor latch plate (2) to the unique, keyed
lower anchor center buckle. Be certain that the seat belt webbing between the top of the seat back and the anchor buckle and the webbing between
the anchor buckle and the retractor mounting bracket is not twisted.
5. Reach under the raised rear seat cushion to access and reinstall the scissors jack into the storage bracket on the floor panel under the rear seat.
6. Lower the right rear seat cushion to its normal seating position.
Rear Center and Left Outboard - Quad Cab
REAR CENTER AND LEFT OUTBOARD - QUAD CAB
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in
possible serious or fatal injury.
