Dakota 4WD V8-4.7L (2009)
1. Position the center or the left outboard occupant buckle unit (2) onto the stud (4) near the base of the cab back panel that secures the inboard rear
seat mounting bracket to the rear floor panel (5).
2. Install and tighten the nut (3) that secures the buckle unit to the stud. Tighten the nut to 41 Nm (30 ft. lbs.). Be certain to hold the buckle in its
properly oriented position while tightening the nut.
3. Push the buckle up through the crevice between the rear seat cushion and the rear seat back.
4. Lower the rear seat cushion back to its normal seating position.
5. Engage the buckle through the elastic loop at the back of the seat cushion.
Rear - Club Cab
REAR - CLUB CAB
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in
possible serious or fatal injury.
1. Position the lower anchor of the rear seat belt buckle (2) to the rear floor panel (4).
2. Install and tighten the screw (3) that secures the buckle anchor to the floor panel. Tighten the screw to 46 Nm (34 ft. lbs.).
3. Fold down the rear seat cushion from the cab back panel (1) to the seating position.
