dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Seat Belt Retractor - Removal|Page 5977 > < Seat Belt Retractor - Removal|Page 5975
Page 8
background image

4. Route the seat belt, lower anchor, latch plate and turning loop (3) through the clearance holes in the lower C-pillar trim (7). Be certain that the seat

belt webbing between the retractor and the lower anchor is not twisted.

5. Position the seat belt lower anchor to the mounting hole in the floor panel near the base of the C-pillar.
6. Install and tighten the screw (6) that secures the lower anchor to the floor panel. Tighten the screw to 39 Nm (29 ft. lbs.).
7. Reinstall the lower trim onto the inside of the C-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar

Trim/C-Pillar Trim Panel-Installation.

8. Reinstall the upper trim (2) onto the inside of the C-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar

Trim/C-Pillar Trim Panel-Installation.

9. Position the seat belt turning loop to the mounting hole in the upper C-pillar.

10. Install and tighten the screw (5) that secures the seat belt turning loop to the C-pillar. Tighten the screw to 39 Nm (29 ft. lbs.).
11. Engage the tab on the lower edge of the trim cover (4) in the slot below the screw in the turning loop. Then press the upper edge of the trim cover

over the top of the turning loop until it snaps into place.

Rear Outboard - Quad Cab

REAR OUTBOARD - QUAD CAB

WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,

buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in
possible serious or fatal injury.

Seat Belt Retractor - Removal|Page 5977 > < Seat Belt Retractor - Removal|Page 5975