Dakota 4WD V8-4.7L (2009)
5. Connect the starter solenoid wire harness connector (1).
6. Raise the vehicle on a hoist, See: Maintenance/Vehicle Lifting/Service and Repair.
7. Install the nut (2) securing the cable (1) to the starter solenoid (3). Tighten the nut to 13 Nm (115 in. lbs.).
8. Connect the battery cable retaining pushpin (6) securing the cable to the engine block.
9. Lower the vehicle.
10. Connect the battery positive cable terminal clamp (8). Tighten the battery terminal clamp pinch-bolt hex nut to 5 Nm (45 in. Lbs.).
11. Position the resonator (4) into the vehicle. Install the bolts (3) into the air intake resonator (4) and tighten the band clamp (2) on the air inlet tube
(1).
