Dakota 4WD V8-4.7L (2009)
Front Steering Knuckle: Service and Repair
Front Steering Knuckle - Installation
INSTALLATION
CAUTION: The ball joint stud tapers must be CLEAN and DRY before installing the knuckle. Clean the stud tapers with mineral spirits to
remove dirt and grease.
1. Install the hub/bearing to the steering knuckle and tighten the bolts (1) to 163 Nm (120 ft. lbs.).
2. Install the knuckle (7) onto the upper (2) and lower ball joints (5).
3. Install the upper (1) ball joint nut. Tighten the nut to 95 Nm (70 ft. lbs.).
4. Install the lower ball joint nut (6). Tighten the nut to 129 Nm (95 ft. lbs.).
5. Remove the hydraulic jack from the lower control arm (4).
