Dakota 4WD V8-4.7L (2009)
CAUTION: Failure to follow these instruction may result in a driveline vibration.
5. Crimp the CV boot clamp.
6. Install skid plate, if equipped.
Rear
INSTALLATION
NOTE: Flange bolts incorporate a Loctite(R) patch, new bolts should be used. If new bolts are not available, clean bolts and apply Mopar(R)
Lock & Seal Adhesive, or equivalent to the threads.
CAUTION: Failure to follow these instructions may result in a driveline vibration.
1. Slide slip yoke (1) onto automatic transmission/transfer case output shaft (2) with reference marks aligned.
2. If equipped with manual transmission, align transmission flange (1) and propeller shaft reference marks. Install flange bolts (2) and tighten to 115
Nm (85 ft. lbs.).
