Dakota 4WD V8-4.7L (2009)
3. Install the new front output shaft seal slinger (1) into position on the output shaft (2).
4. Install the front output shaft seal slinger with Installer 10117.
5. Install the seal boot (2) onto the seal slinger (3)
6. Install a new seal boot clamp onto the seal boot, at the seal slinger, and tighten the clamp with Crimp Tool C-4975A.
7. Install the front propeller shaft. See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Removal and
Replacement/Drive Shaft - Installation
8. Check the transfer case fluid level and correct as necessary. See: Service and Repair/Procedures