Dakota 4WD V8-4.7L (2009)
Front Door Window Regulator: Service and Repair
Front Door Window Regulator - Installation
Power
INSTALLATION
1. Place the regulator into the door and engage the bolts (3 and 4) into the keyhole slots in the door (1).
2. Install the one bolt at the motor.
3. Install the two lower bolts (5).
4. Tighten all the regulator bolts to 9.5 Nm (85 in. lbs.).
5. Connect the electrical connector (6).
6. Remove the tape used to secure the glass during removal and position the glass (1) into the glass clamps.
7. Temporarily install the window switch and raise the glass into the full up position.
8. Tighten the glass clamp screws (2) securely.
