Dakota 4WD V8-4.7L (2009)
NOTE: Typical primer installation shown.
10. Clean and dry area of glass (2) to be re-glued with a suitable glass preparation solvent and rag.
11. Using a flash light, verify that glass primer is without damage.
12. Re-prime any damaged area. If old adhesive has been exposed for more than 12 hours, entire adhesive area needs to be re-primed.
13. Apply primer (1) around the perimeter of the glass to a width of 15 mm (0.5 in.) (2).
14. Allow primer to air dry for at least 10 minutes.
15. Using a flash light, verify that glass primer is without damage.
Windshield Preparation - Installing A New Windshield
1. Apply four new spacers (1) to the a-pillars and place them evenly apart at the top and bottom.
2. Install the lower spacer assemblies (2) into the slotted holes and verify proper installation by pulling to make sure they are locked on.
NOTE: Lower spacers must be facing with the flat side upwards when installing into the slotted holes.
