Dakota 4WD V8-4.7L (2009)
Wiper Motor Linkage: Service and Repair
Wiper Arm Linkage - Removal
REMOVAL
1. Remove both wiper arms from the wiper pivots. See: Wiper Arm/Service and Repair/Wiper Arm - Removal.
2. Unlatch and open the hood.
3. Disconnect and isolate the battery negative cable.
4. Remove the cowl plenum cover/grille panel from over the cowl plenum (1). See: Body and Frame/Cowl/Cowl Moulding / Trim/Service and
Repair/Cowl Panel Cover - Removal.
5. Remove the four screws (2) that secure the wiper module (3) to the cowl plenum panel.
6. Disconnect the headlamp and dash wire harness connector (4) from the wiper motor pigtail wire connector.
7. Remove the wiper module from the cowl plenum panel as a unit.
