dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Carpet - Removal|Page 8171 > < Carpet - Removal|Page 8169
Page 4
background image

13. Install the cowl trim panels, See: Trim Panel/Service and Repair/Cowl Trim/Cowl Trim - Installation.

14. Install the outer front seat belt retractor covers, See: Trim Panel/Service and Repair/Cover-Outer Front Seat Belt Retractor/Installation.
15. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed

following service of any supplemental restraint system component. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests.

Club Cab, With Rear Jumper Seats

WARNING: To avoid personal injury or death, on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, occupant classification system, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge
before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the
proper precautions could result in accidental airbag deployment.

WARNING: To avoid personal injury or death, during and following any seat belt or child restraint anchor service, carefully inspect all seat
belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is
cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or inoperative buckle
or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which
the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged
or faulty seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler Mopar(R)
Parts Catalog.

NOTE: Carpet for Quad Cab models shown. Club Cab similar.

1. For vehicles equipped with a manual shift transmission, remove the cutout (2) from the carpet for the shifter assembly.
2. Position the carpet (1) in the vehicle.

Carpet - Removal|Page 8171 > < Carpet - Removal|Page 8169