Dakota 4WD V8-4.7L Flex Fuel (2008)
10. Position the retractor (1) mounting bracket to the mounting holes in the floor panel inboard of the door sill (4). Be certain that the seat belt
webbing between the retractor and the turning loop is not twisted.
11. Install the two screws (2) that secure the retractor bracket to the floor panel. Tighten the screws to 39 Nm (29 ft. lbs.).
12. Reconnect the body wire harness connector (3) to the seat belt tensioner initiator on the retractor.
13. Install the rear door sill scuff plates, See: Scuff Plate/Service and Repair/Door Sill Scuff Plate - Installation.
NOTE: Cowl trim panel for Quad Cab models shown. Club Cab similar.
14. Install the cowl trim panels, See: Trim Panel/Service and Repair/Cowl Trim/Cowl Trim - Installation.
