Dakota 4WD V8-4.7L Flex Fuel (2008)
Keyless Entry Module: Service and Repair
Sentry Key Remote Entry Module - Installation
INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service.
Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing
further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental
airbag deployment.
1. Position the Sentry Key REmote Entry Module (SKREEM) (1) onto the steering column with the antenna ring (3) oriented around the ignition lock
cylinder housing (4).
2. Install and tighten the screw (2) that secures the SKREEM to the steering column housing. Tighten the screw to 2 Nm (20 in. lbs.).
3. Reconnect the wire harness connector (2) to the SKREEM (1).
4. On vehicles equipped with the optional remote start system, reconnect the coaxial cable to the coaxial connector receptacle on the SKREEM.
