Dakota 4WD V8-4.7L Flex Fuel (2008)
Wheel Speed Sensor: Service and Repair
Rear Wheel Speed Sensor - Installation
INSTALLATION
1. Connect harness to sensor (1). Be sure seal is securely in place between sensor and wiring connector.
2. Install O-ring on sensor (if removed).
3. Insert sensor (1) in differential housing (3).
4. Install the sensor mounting stud and tighten to 24 Nm (200 in. lbs.).
5. Reconnect the electrical connector (6).
6. Install the brake line (3) on the sensor stud.
7. Install the park brake cable (2) and bracket (1) to the stud and install the nut (4).
8. Lower vehicle.
