Dakota 4WD V8-4.7L Flex Fuel (2008)
Electronic Brake Control Module: Service and Repair
Installation
INSTALLATION
NOTE: If the ABM needs to be replaced, the rear axle type and tire revolutions per mile must be programed into the new ABM. For axle type
refer to Differential See: Transmission and Drivetrain/Differential Assembly/Specifications/Mechanical Specifications. For tire revolutions per
mile See: Maintenance/Wheels and Tires/Tires/Specifications. To program the ABM refer to the Appropriate Diagnostic Information.
1. Position the module (1) on the HCU (2).
2. Install the mounting screws (1) and tighten to 6 Nm (53 in. lbs).
3. Install the pump electrical connector (3) to the module (4).
