Dakota 4WD V8-4.7L Flex Fuel (2008)
CAUTION: The bedplate to cylinder block mateing surface must be coated with sealant prior to installation. Failure to do so will cause severe
oil leaks.
NOTE: The parts must assembled and tightened within 10 after applying sealer.
NOTE: Make sure that the bedplate and cylinder block sealing surfaces are clean and free of oil or other contaminants. Contaminants on the
sealing surfaces may cause main bearing distortion and/or oil leaks.
4. Apply a 2.5 mm (0.100 inch) bead of Mopar(R) Gen II Silicone Rubber Adhesive sealant (2) to the cylinder block-to-bedplate mating surface (1)
as shown.
5. Coat the crankshaft main bearing journals with clean engine oil and position the bedplate onto the cylinder block.
NOTE: Lubricate the bedplate retaining bolts with clean engine oil prior to installation.
6. Install the bedplate retaining bolts, making sure to place the stud bolts in the correct location, Torque the bolts in the sequence shown.
-
Tighten bolts A - L to 54 Nm (40 ft. lbs.)
-
Tighten bolts 1-10 to 2.8 Nm (25 in. lbs.)
-
Turn bolts 1-10 an additional 90°.
-
Tighten bolts A1- A6 to 27 Nm (20 ft. lbs.)
7. Measure crankshaft end play. See: Specifications/Engine Specifications.
8. Install the connecting rods and measure side clearance. See: Connecting Rod Bearing/Service and Repair.
