Dakota 4WD V8-4.7L Flex Fuel (2008)
Air Door Actuator / Motor: Service and Repair
Mode Door Actuator - Installation
INSTALLATION
NOTE: This heater-A/C system is equipped with two mode door actuators. One for the floor/defrost-air door and one for the panel-air door.
FLOOR/DEFROST DOOR ACTUATOR
1. Position the floor/defrost door actuator (1) onto the driver side end of the HVAC housing (2). If necessary, rotate the actuator slightly to align the
splines on the actuator output shaft (3) with those on the floor/defrost door pivot shaft (4).
2. Install the three screws (1) that secure the floor/defrost door actuator (2) to the HVAC housing (3). Tighten the screws to 2 Nm (17 in. lbs.).
3. Connect the HVAC wire harness connector (4) to the floor/defrost door actuator.
4. Reconnect the negative battery cable.
5. Initiate the Actuator Calibration function using a scan tool.
PANEL DOOR ACTUATOR
