Dakota 4WD V8-4.7L Flex Fuel (2008)
NOTE: If the seal on any air door is deformed or damaged, the air door must be replaced.
3. Install both blend-air doors (4) and the defrost/floor-air door (5) into the HVAC housing.
4. If removed, install the rubber flange (3) over the evaporator tubes (4).
NOTE: Make sure that the evaporator drain is clean and unrestricted and that the rubber seal and the rubber flange are properly
positioned in the HVAC housings.
NOTE: If the A/C evaporator is being replaced, add 60 milliliters (2 fluid ounces) of refrigerant oil to the refrigerant system. Use only
refrigerant oil of the type recommended for the A/C compressor in the vehicle.
5. Carefully install the A/C evaporator (1) into the lower half of the HVAC housing (2).
6. If removed, install the rubber flange (3) over the heater core tubes (4).
NOTE: If the foam seal around the heater core is deformed or damaged, the seal must be replaced.
NOTE: Make sure that the foam seal and the rubber flange are properly positioned in the HVAC housing.
7. Carefully install the heater core (1) into the lower half of the HVAC housing (2).
