Dakota 4WD V8-4.7L Flex Fuel (2008)
Spark Plug: Service and Repair
Spark Plug - Removal
REMOVAL - 4.7L V-8
CAUTION: This engine uses TWO DIFFERENT types of spark plugs. A total of 16 plugs is used. The plugs are mounted in two rows (banks).
The upper row (5) is used on the intake valve side of the cylinder head. The lower row (6) is used on the exhaust valve side of the cylinder head.
The upper row (5) uses Bosch Nickel Yttrium plugs #05149050AB. The lower row (6) uses Bosch Iridium plugs #05149888AA. DO NOT
INTERCHANGE THESE PLUGS.
CAUTION: Do not attempt to clean any of the spark plugs. Replace only.
1. Remove necessary air filter tubing and air intake components at top of engine and at throttle body.
2. To remove the upper row of plugs (5), each individual ignition coil (2) must first be removed. See: Powertrain Management/Ignition
System/Ignition Coil/Service and Repair/Ignition Coil - Removal Prior to removing ignition coil, spray compressed air around coil base at cylinder
head.
3. Prior to removing spark plug, spray compressed air into cylinder head opening. This will help prevent foreign material from entering combustion
chamber.
CAUTION: Due to tight clearances between UPPER row of plugs (5) and cylinder head, a conventional deep, thick-wall spark plug
socket will not fit. Use a deep, THIN-WALL 5/8" spark plug socket for plug removal and installation.
4. Inspect spark plug condition.
