Dakota 4WD V8-4.7L Flex Fuel (2008)
Fuel Supply Line: Description and Operation
DESCRIPTION
Also See: Fuel Line Coupler/Description and Operation
WARNING: The fuel system may be under a constant pressure (even with the engine off). Before servicing any fuel system hoses, fittings, lines,
or most components, fuel system pressure must be released. See: Fuel Filter/Fuel Pressure Release/Service and Repair
The lines/tubes/hoses used on fuel injected vehicles are of a special construction. This is due to the higher fuel pressures and the possibility of
contaminated fuel in this system. If it is necessary to replace these lines/tubes/hoses, only those marked EFM/EFI may be used.
If equipped: The hose clamps used to secure rubber hoses on fuel injected vehicles are of a special rolled edge construction. This construction is used
to prevent the edge of the clamp from cutting into the hose. Only these rolled edge type clamps may be used in this system. All other types of clamps
may cut into the hoses and cause high-pressure fuel leaks.
Use new original equipment type hose clamps.
